Use a coin or flathead screwdriver to make adjustments or “clicks”ģ. In order to make windage and elevation adjustments:Ģ. The click value is 1 MOA, so each click moves the point of impact 1” at 100 yards, The Firefield Impulse 1x30 Red Dot Sight has built-in windage and elevation adjustments (2, 3) withĪudible clicks. OPERATING WINDAGE AND ELEVATION ADJUSTMENTS: Tighten the hex nut to 35 to 45 in/lbs of torque using the hex wrench. Make sure the recoil bolt is positioned in the groove of the rail and the unit is fully seated onģ. The objective lens facing toward the muzzle and the eyepiece toward the user.Ģ.
Attach the sight to the firearm’s rail with Loosen the mounting hex nut (12) on the mount. For safety it isīest to have at least three to four inches of eye relief.ġ. The Firefield Impulse 1x30 Red Dot Sight is designed to mount to picatinny rails. To decrease brightness press the down arrow To increase brightness press the up arrow.ģ. Press the appropriate up or down arrow (8) to adjust the brightness of the dot.Ģ. Settings 1 and 2 are bestįor low light, indoor environments while 3-6 are best for outdoor environments.ġ. The Firefield Impulse 1x30 Red Dot Sight offers 6 brightness settings. Press and hold the on/off control for 3 seconds. Press and release the on/off control (7).ġ. Screw the battery cap on clockwise until firmly secure. Insert the new battery into the battery compartment (5) with the negative (-) side inserted first.ģ. Unscrew the battery cap (6) counterclockwise.Ģ. Illumination grow dim or fail to illuminate, the battery needs to be replaced.ġ. The Firefield Impulse 1x30 Red Dot Sight is powered by a single CR123A battery.
0 kommentar(er)
